DIY Mid-Century Plant Stand - A Step By Step Guide

Believe it or not it's easier than you retrieve to make your own mid-century constitute stand that's perfect for your porch or sunroom! Plant with succulents to colorful blooms to brilliant up any corner!

Supplies you'll need to build a mid-century establish stand up:

Planter
Saw
Drill
Wood dowel
Forstner drill bit (coordinating diameter with your woods dowel)
Forest glue
ane×i″ woods boards
1X2″ wood boards
Pencil
Sanding cake or paper
Hammer

Supplies you'll need to build a mid-century plant stand

How to build the mid-century establish stand step past step:

Footstep 1: Measuring and cutting

You will start this project by measuring yous planter. Your dimensions for this project volition be completely based on the planter that you lot use and the dimensions that you size. Yous will want to mensurate the height, width and depth of the planter. If you use a round or square (vs. oblong) planter this will make it much easier. Accept your local hardware shop cut 1×1″ and 1×2″ boards to your specific dimensions. You will need iv long pieces that will serve every bit legs (your top plus whatever extra height yous want off the ground) cut from your one×1″ boards and 3 shorter pieces (cut based on your dimensions from the bore) cut to size. One will be the exact diameter of the planter and the other two volition be the the diameter minus the width of the board divided by two.

Step two: Set up the bore

Mark the center of your longer diameter slice in the center.

Step iii: Drilling process

Drill two centered holes all the manner through for your wood pegs equal altitude apart (try for a strict measurement similar 2 inches to be consistent throughout the piece). Also drill holes into the ends of each of the smaller 1×ii″ pieces (both sides) approximately 1 inch deep.

Step 4: Woodcutting

Cut your dowel rod into smaller pieces (approximately 2″ each).

Step v: Add the mucilage

Put wood mucilage in the holes on the 1×two″ longer board.

Step half-dozen: Add the dowel

Insert your dowel pieces (longer ones) through the holes in the longer centerboard. Attach your shorter pieces to your long piece in an X shape with dowels and the wood glue.

Step 7: The 2 holes

Drill two holes (once more equal distance apart) in the middle of all 4 of your long legs. Drill all the style through the legs. Identify wood gum and dowels in the ends of the Ten shaped middle and attach your legs on the dowels.

Footstep 8: Put all together

Use a hammer to get your legs and dowels fully into identify and fitting together tightly. Wipe off any backlog wood glue with a moisture cloth.

Step 8: Cut the excess wood

Saw off the excess dowel on the outsides of the legs and sand downward those areas.

Step 9: Add together the soil and plants

Place your planter in the forest base and information technology should fit nice and snug! Permit the whole matter dry overnight. Finish the wood if you're going to keep information technology outside (here we merely used a calorie-free vegetable oil since it was used on a porch simply a polyurethane protective terminate is a keen option too).

Step 10: Painting

Lastly, plant your planter with rocks, soil, and colorful florals or fun succulents!

DIY Mid Century Inspired Planter Top View

DIY Mid Century Inspired Planter Project

schellseld1940.blogspot.com

Source: https://www.homedit.com/mid-century-planter/